Restrained ornamentation and a refined decorative look is the order of the day for Crystal lighting. Fixtures in this class usually have a smaller scale compared to the more Baroque-era grandiose fixtures with more excessive design elements.

Often times; Crystal lighting styles will have distressed tones that resemble their vintage-style lighting counterparts, but with heavier design elements and more intricate detail while using crystal as an accent to project the light in a visually pleasing pattern. An intricate pattern in an antique bronze finish with crystal inlays without invoking the more flared styling that is typical of earlier period lighting is a great example of Crystal lighting.

By providing early warning in the event of fire, smoke detectors can allow you and your family sufficient time to reach safety. Experts report that you can increase your chances of surviving in a home fire by 50% simply by having smoke detectors. Click here for more information about installing  smoke detectors in Los Angeles, my electrical company’s service area.

If your house was built before 1950, it likely has electrical wires with cloth insulation. Over time, the cloth dries out and becomes brittle. Eventually, it crumbles off the wire, exposing bare wires that can short-circuit and cause shocks or fires. Old cloth-insulated wires should be replaced with plastic-insulated wires. Plastic insulation lasts indefinitely and completely resolves the safety issue. Click here for more information about replacing cloth  wiring insulation.

The National Electrical Code requires that outlets in the vicinity of water be equipped with a device called a “Ground Fault Circuit Interrupter” or GFCI (also called GFI). GFCIs are required in all bathrooms, kitchens, garages, pools, and some outdoor areas. GFCIs can protect your family against deadly electrical shocks and are inexpensive to install. Click here for more information about GFCIs and GFIs.

Knob & Tube wiring gets its name from the white ceramic knobs around which wires were wound and the short ceramic tubes through which wires were guided. This type of wiring is usually found in homes built before 1935. In the Los Angeles and some other parts of the country, knob and tube can sometimes be seen in houses built as late as 1950. My electrical company specializes in replacing Knob and Tube wiring in the L.A. area — much of it is in Pasadena and other parts of the San Gabriel Valley.

Knob & Tube systems use old cloth-insulated wires and are not grounded. We strongly recommend that Knob & Tube wiring be replaced to eliminate fire and electrical shock hazards.

An electrical surge is a sudden increase in power that flows through electrical wires. Surges can cause damage to computers, phones, entertainment systems, microwaves, stoves, fridges, washers – any device that has electronic components such as sensors and timers. Today, that’s most appliances. A Whole House Surge Protector can save your appliances and electronic devices and save you thousands of dollars in damage.

Look for our $50 discount coupon for the installation of whole house surge protectors at www.theelectricconnection.com.

A properly grounded electrical system routes occasional leaking electricity through a “ground wire” into the ground. Without grounding, excess electricity can cause fires, damage to electrical appliances and computers, and also shocks to residents.

Older homes built under earlier electrical codes will often have outlets for two-prong plugs. This is often an indication of an ungrounded electrical system. Sometimes, the outlets have been replaced with the modern three-prong type, but without actually adding a ground wire. This can make it appear that the system is grounded when it’s not.

Even when your wiring system has a ground wire, the grounding may fail due to loose or corroded connections and splices. A qualified electrician can check your wiring with a special tester to determine if it’s fully grounded. The Electric Connection offers this testing as a free service with every electrical job that we do in the L.A. area.

There is now conclusive evidence that both Zinsco and Federal Pacific Electric (FPE) “Stab-Lok” electrical panels can fail. (Electrical panels contain your circuit breakers or fuses.) Fires and electrical shocks can result. These brands were installed in the 1950s to 1980s. The failure rates as they age are much higher than for other brands and represent a real electrical hazard. We recommend all Zinsco and FPE electrical panels and circuit breakers be replaced with modern electrical equipment. Click here for more information about Zinsco and Federal Pacific electrical panels. One of the specialties of The Electric Connection is panel upgrades. We’re possibly the most active company in Los Angeles when it comes to electrical panel replacements. We offer a free safety check of your L.A. electrical panel box with every job.

Circuit breakers and fuses protect your electrical wiring from overloads of electricity. Overloading can melt wires and cause fires and electrical shocks. Whenever a wire is overloaded, the circuit breaker or fuse is supposed to cut the flow of electricity.

Sometimes older circuit breakers don’t work fast enough and allow too much current through. Fuses can also be a safety concern. Sometimes, they’ve been replaced with improperly-sized fuses and no longer protect wires from overloading. These safety issues can be solved by installing modern circuit breakers. Click here for a coupon for a free check of your electrical circuit breaker box with your next electrical job.

Most homes have copper electrical wires. However, from the mid-1960s to the mid-1970s, over 2,000,000 U.S. homes were wired with aluminum. The U.S. Consumer Products Safety Commission has determined that aluminum wiring is hazardous as, over time, connections and splices can fail, resulting in fires and shocks.

Fortunately, a qualified electrician can upgrade an aluminum wiring system without replacing all the wires with copper. It’s possible to eliminate the fire hazard by upgrading only connection points and splices. Aluminum wiring safety retrofits should be done only by electricians specifically trained to upgrade aluminum wiring safely.

If you think it’s possible that your Los Angeles home has aluminum wiring, you can get a free checkwith your next electrical job. One of the specialties of The Electric Connection is efficient and effective safety upgrading of aluminum wiring in the Los Angeles area.

Click here to visit our website.

Flush or Semi Flush?

Flush mount and semi-flush mount lighting fixtures are integral components in lighting design, adding interest and depth while providing ambient illumination and decorative lighting effects to hallways, bedrooms and bathrooms.

The difference between a flush and semi-flush light fixture is that a flush fixture fits snugly to the ceiling, while a semi-flush fixture is suspended, leaving a small gap between the ceiling and fixture.  Opting for a flush or semi-flush light fixture is based upon taste and proportional considerations, but a few standard rules apply:

♦ Semi-flush—Somewhere in between the chandelier and standard ceiling fixture, the semi-flush fixture shines with distinction.  Taking up just the right amount of space with the power to attract desired attention, the latest semi-flush light fixtures provide superb illumination with artistic excellence.

♦  Semi-flush fixtures provide an added benefit: the small gap allows for double the illumination with indirect uplight rebounding off the ceiling and downlight emitted directly from the fixture.

♦  Flush fixtures—Most often employed in homes with standard 7-foot ceilings to provide general illumination for bedrooms, bathrooms, foyers and hallways.

Novel compositions and unique finishes are available at a variety of price points and are being featured from top lighting vendors around the world, making it easier than ever to find ceiling light fixtures in keeping with your budget and style requirements.

Corbett Lighting offers outstanding flush and semi-flush lighting designs:

-CQ33 “Cirque” Semi- Flush Fixture

-120-33 “Karma” Flushmount Fixture

38 million people in the U.S. that has migraines or study published in a 2016 issue of Brain shows that green LED lighting reduced pain intensity by 20 percent. In the study, “Migraine photophobia originating in cone-driven retinal pathways,” researchers at the Beth Israel Deaconess Medical Center set out to test whether or not colors can affect photophobia and migraine intensity. Photophobia is sensitivity to light and can be associated with pain and migraine exacerbation. Findings in a previous study fueled the motivation for this study. In the earlier study, the researchers found that blind participants experienced increased migraine pain when exposed to blue light.

Sixty-nine participants with migraines were part of the most recent study. Researchers studied the effects that exposure to white, blue, green, amber, and red low-intensity light had on their pain. Blue and red light were the worst—increasing pain by 18-19 percent. White and amber increased pain by 15 percent. Green was the only color that reduced pain.

Another green-light study found that exposure to low-intensity light from green LEDs reduced chronic pain and migraine severity. In this study, eight participants with fibromyalgia or migraines were given a green LED strip light, and five were given a white strip. Participants were asked to use their strips nightly for one to two hours for 10 weeks. Participants with green LEDs reported a 40-50 percent drop in pain.

The study was so successful for some that they asked to keep their green LED strip lights; they continue to use them in addition to or in place of medicine. In a study was published in a 2017 issue of Pain. The University of Arizona study, “Long-lasting antinociceptive (pain blocking) effects of green light in acute and chronic pain in rats,” found that rats experienced an increased tolerance for thermal and tactile testing methods. These tests measured how long it took for the rats to withdraw their paw when exposed to heat or pricked with a filament. Testing was completed under green or white light. The researchers found that after eight hours of green LED light exposure for five days it took much longer for rats to withdraw their paws. Effects of the green LEDs lasted for four days.

Rajesh Khanna, UA associate professor of pharmacology and senior author of the study, reports that, “While the pain-relieving qualities of green LED are clear, exactly how it works remains a puzzle. Early studies show that green light is increasing the levels of circulating endogenous opioids, which may explain the pain-relieving effects.”  In a UA article, “(Exogenous) Opioids, while having many benefits for managing pain, come with serious side effects.” These medications can also be addictive.

Researchers in this study are not advising people to stop their medications without speaking with a professional. However, it is possible, as in Lesneski’s case, that green LED lighting could eliminate the need for them in the future. “We need safer, effective and affordable approaches, used in conjunction with our current tools, to manage chronic pain,” Ibrahim said.

Compact fluorescent lamps (CFLs) are good substitute to the now being banned incandescent lamps. It is more energy efficient and lasts longer than its counterpart. CFLs are more expensive because the price includes the disposal fee. It was introduced in North America in mid 1990s. Although it is more energy efficient than the incandescent lamps, its composition makes its disposal complicated. CFLs are known to contain mercury which is a very serious threat to the environment once disposed improperly. Mercury functions as the vapor inside the glass tubing of CFLs. Usually CFLs contains around 3-5 mg of Mercury; some have it as low as 1 mg. In essence, Mercury is utilized as vapor in a phosphor tube, which when electricity pass through, it produces short-wave UV (ultraviolet light) which causes the phosphor to fluoresce, therefore making visible light.

Mercury or Hydrargyrum or quicksilver is a liquid metal with a symbol Hg. Mercury is a poisonous chemical that can be derived from major deposits as cinnabar or mercuric sulfide, the reason for vermilion, the red pigment responsible for the reddening of the soil. The poisonous substance can be ingested or inhaled mercury vapor or by eating mercury contaminated fish. Mercury poisoning which is also known as mercurialism or hydrargyria is the disease that can be derived from exposure to mercury or its components. Acrodynia, Hunter Russell syndrome and Minamata disease are among the list of those mercury related diseases. It affects body senses such as impaired vision, hearing and speech. Disturbed sensation and lack of body coordination are also among the symptoms.

Imagine the world full of mercury-filled CFLs, time will come that the number one cause of human fatality is mercury poisoning. Steps are being taken into account for the eradication of CFLs. By the year 2015, the government of the United States of America will implement the banning of use of CFLs to stop the possible exposure to mercury. Although it is expected that many users of CFL will stop this banning procedure, a lot of informative measures are being given to the public to further understand why the government is pursuing this act.

When this thing comes into action and given that the incandescent bulbs will as well be phased-out, what can substitute CFLs as lighting solution? Majority are thinking that LED lamps are the next thing to be on the spot light to cater all the lighting requirement of the world.

LED lamps can be considered a viable means as alternative to the prevailing lighting system which are expected to be obsolete in the years to come. LED lamps are a lot more beneficial to employ than those two. Imagine the comfort one can have if for a long time, around 10 – 13 years, he will not be thinking of replacing bulbs and maintaining it. Additionally, LED lamps are comparatively using very low energy and still can give-out the equivalent brightness and luminance compared to its counterpart. Considering the price of purchasing LEDs, one just have to consider LED lighting as an investment that will definitely pay-off in the years to come.

Ample information should have to be distributed to further inform the public regarding the practical benefits of choosing LED bulbs over the other lighting options available today.