There are many reasons and advantages of LED street lights over HPS, Metal Halide, and any other HID light used in the street lighting industry. These advantages of LED street range from cost savings, higher quality of light, and overall better efficiency.

LED is quickly becoming the “go to” light for all uses; residential, commercial, and industrial. From fully replacing and retrofitting LED is seriously becoming the majority within the world of lighting. The following list is going to cover 4 major advantages of LED street lights over HPS and Metal Halide, hopefully it shines some light on the true benefits of LED for even Metal Halide, you get results that show LEDs actually really do pay for themselves. If you use your lights often, making the switch to LED street lights may even pay themselves off within a few years.

If you’d like to see how much you could save, check out the diminishes over time. This is a highly important thing to note because with greater lumen depreciation comes added costs of maintenance.

Lighting fixtures such as HPS and Metal Halide have lumen depreciation that happens much earlier in their life and much quicker throughout the bulbs life. Whereas an LED takes a longer time to start depleting in it’s lumen output and much slower lumen depreciation than HPS and Metal Halide does.

While not all LED suppliers and manufacturers, MyLEDLightinGuide.com offers LED fixtures and retrofit kits that can produce at a very high MyLEDLightingGuide retrofit kits can run as high as 151 lumens per watt. While the typical retrofit kits on the marketplace (on average) run at only around 110 lumens per watt.

This is just a prime example of how powerful lumens per watt can be. The more lumens per watt you get, the less watts you will need to produce the same amount of light.

So, let’s compare the “average” retrofit kits compared to a Metal Halide light. Remember, the “average” retrofit kits run at around 110 lumens per watt. Compare that to a Metal Halide light that runs around (on average) 90 lumens per watt.

So just by these numbers we can start to see the power LED lights have and how they need less watts to produce the same amount of light that a HPS or Metal Halide light does.

In addition to #3 on this list, LEDs also provide a higher quality of light measure by the Color Rendering Index (CRI). Here’s two images that should do the talking:

Street Light Conversion From 400W Metal Halide to 120W LED using a LED Retrofit Kit (before)

As you can see after the 400W Metal Halide was replaced by the 120W LED fixture, the light produced is much brighter and illuminates a greater area. On top of that, it is using way less energy (400W down to 120W)!

Brighter and greater illumination can greatly increase safety and reduce crime by the simple fact of being able to see more throughout the night. Better illumination also creates safer roadways by not leaving any dark spots that may cause issues for drivers during night time driving.

Lately, there has been a lot of buzz about 3D projection mapping. I first heard about it from an electronic music enthusiast who plans to acquire projection mapping software and add this extreme visual component to his live shows. But many people were introduced to projection mapping from the coverage of the Winter Olympics in Sochi this year or from the viral video of projection mapping shown below, a pre-game show on the court floor at a Cleveland Cavaliers game. Prepare to be astonished.