By providing early warning in the event of fire, smoke detectors can allow you and your family sufficient time to reach safety. Experts report that you can increase your chances of surviving in a home fire by 50% simply by having smoke detectors. Click here for more information about installing  smoke detectors in Los Angeles, my electrical company’s service area.

If your house was built before 1950, it likely has electrical wires with cloth insulation. Over time, the cloth dries out and becomes brittle. Eventually, it crumbles off the wire, exposing bare wires that can short-circuit and cause shocks or fires. Old cloth-insulated wires should be replaced with plastic-insulated wires. Plastic insulation lasts indefinitely and completely resolves the safety issue. Click here for more information about replacing cloth  wiring insulation.

The National Electrical Code requires that outlets in the vicinity of water be equipped with a device called a “Ground Fault Circuit Interrupter” or GFCI (also called GFI). GFCIs are required in all bathrooms, kitchens, garages, pools, and some outdoor areas. GFCIs can protect your family against deadly electrical shocks and are inexpensive to install. Click here for more information about GFCIs and GFIs.

Knob & Tube wiring gets its name from the white ceramic knobs around which wires were wound and the short ceramic tubes through which wires were guided. This type of wiring is usually found in homes built before 1935. In the Los Angeles and some other parts of the country, knob and tube can sometimes be seen in houses built as late as 1950. My electrical company specializes in replacing Knob and Tube wiring in the L.A. area — much of it is in Pasadena and other parts of the San Gabriel Valley.

Knob & Tube systems use old cloth-insulated wires and are not grounded. We strongly recommend that Knob & Tube wiring be replaced to eliminate fire and electrical shock hazards.

An electrical surge is a sudden increase in power that flows through electrical wires. Surges can cause damage to computers, phones, entertainment systems, microwaves, stoves, fridges, washers – any device that has electronic components such as sensors and timers. Today, that’s most appliances. A Whole House Surge Protector can save your appliances and electronic devices and save you thousands of dollars in damage.

Look for our $50 discount coupon for the installation of whole house surge protectors at www.theelectricconnection.com.

A properly grounded electrical system routes occasional leaking electricity through a “ground wire” into the ground. Without grounding, excess electricity can cause fires, damage to electrical appliances and computers, and also shocks to residents.

Older homes built under earlier electrical codes will often have outlets for two-prong plugs. This is often an indication of an ungrounded electrical system. Sometimes, the outlets have been replaced with the modern three-prong type, but without actually adding a ground wire. This can make it appear that the system is grounded when it’s not.

Even when your wiring system has a ground wire, the grounding may fail due to loose or corroded connections and splices. A qualified electrician can check your wiring with a special tester to determine if it’s fully grounded. The Electric Connection offers this testing as a free service with every electrical job that we do in the L.A. area.

There is now conclusive evidence that both Zinsco and Federal Pacific Electric (FPE) “Stab-Lok” electrical panels can fail. (Electrical panels contain your circuit breakers or fuses.) Fires and electrical shocks can result. These brands were installed in the 1950s to 1980s. The failure rates as they age are much higher than for other brands and represent a real electrical hazard. We recommend all Zinsco and FPE electrical panels and circuit breakers be replaced with modern electrical equipment. Click here for more information about Zinsco and Federal Pacific electrical panels. One of the specialties of The Electric Connection is panel upgrades. We’re possibly the most active company in Los Angeles when it comes to electrical panel replacements. We offer a free safety check of your L.A. electrical panel box with every job.

Circuit breakers and fuses protect your electrical wiring from overloads of electricity. Overloading can melt wires and cause fires and electrical shocks. Whenever a wire is overloaded, the circuit breaker or fuse is supposed to cut the flow of electricity.

Sometimes older circuit breakers don’t work fast enough and allow too much current through. Fuses can also be a safety concern. Sometimes, they’ve been replaced with improperly-sized fuses and no longer protect wires from overloading. These safety issues can be solved by installing modern circuit breakers. Click here for a coupon for a free check of your electrical circuit breaker box with your next electrical job.

Most homes have copper electrical wires. However, from the mid-1960s to the mid-1970s, over 2,000,000 U.S. homes were wired with aluminum. The U.S. Consumer Products Safety Commission has determined that aluminum wiring is hazardous as, over time, connections and splices can fail, resulting in fires and shocks.

Fortunately, a qualified electrician can upgrade an aluminum wiring system without replacing all the wires with copper. It’s possible to eliminate the fire hazard by upgrading only connection points and splices. Aluminum wiring safety retrofits should be done only by electricians specifically trained to upgrade aluminum wiring safely.

If you think it’s possible that your Los Angeles home has aluminum wiring, you can get a free checkwith your next electrical job. One of the specialties of The Electric Connection is efficient and effective safety upgrading of aluminum wiring in the Los Angeles area.

Click here to visit our website.

In case there is a flash flood or storm in your area or if there is a severe plumbing leak or pipe burst, that can result in flooding of water in different areas of your home. Water can cause a lot of damage to the installations and features on your property, and you would have to start the clean-up and repairs without delay. This is also when you start evaluating what can be salvaged and what would have to be replaced – and this includes your home’s wiring.

The wiring inside the walls can become dysfunctional and dangerous if it’s exposed to or submerged in water. If there is a severe flood, it becomes important to completely replace the wiring in your home. Not too many builders actually use wiring that’s rated for water exposure of this kind. Of course, not much can be done till the time all the flood water recedes and all the water has been cleared out from your home.

Even when all the water is pumped out from the indoor spaces, it’s best to shut down the electricity supply at the circuit box mains before continuing with anything. Call in your local electrician to test the wiring in your home. Even if it is still in a working condition, it’s never a good idea to use it.

The insulation can get degraded and that can raise the chances of an electrical fire in the future. In addition, when there are traces of moisture in the wiring, that leads to mould & mildew growth and the metal parts in the system can corrode. This is especially the case when the property has become flooded with salty water.

When it comes to rewiring jobs, you also have to factor in the cost of opening up the wall panels and fixing them. In instances of a flood, the walls are generally torn down right up to the framework. If you take this opportunity to upgrade the wiring in your home, you can save a significant amount of money.

Floodwater is never clean and that proves to be an additional hazard to the wiring and other installations in your home. Chemicals, oil, sewage and a number of other contaminants that come with the floodwater work their way into the smallest spaces, and this is why it’s best to just start afresh with the installation. In comparison, if your home’s wiring has been impacted by water from a burst pipe, you might be able to save these features; this is because it may not be fully-submerged in water.

However, it’s never a good idea to test the condition of the wiring yourself and you should call in a skilled and licensed electrician to thoroughly check and evaluate the installation and give their opinion. Regardless of whether the wiring in your home has got impacted by flood water or water from a damaged plumbing installation, it’s important to get it checked without delay. The professionals will provide suitable solutions based on the condition and location of the wiring.

We realize there are a lot of different Des Moines electricians.  However, we want you to understand what sets us apart.  Our electricians can give you an upfront price right on the job site.  That way you know exactly what the job will cost before the work begins.  We give you a set price to work within your budget so you have peace of mind.  If the job takes longer than expected it will be no additional cost for you.  When our electricians arrive at your home they will greet you with a warm smile and friendly handshake.  They are professional and courteous every step of the way.  We always work to State and National Electrical Codes so you know the job will be completed to code. Our staff is familiar with the Des Moines electrical inspectors and have a quality relationship with them built on trust and professionalism.

Is your home or property not up to code?  Give us a call and we can help.  One of our professionals can perform a minimum code update or rewire your entire home.  We can add new circuits, dedicated circuits, GFCI installations, ground an outlet, and much much more.  Maybe you want something more aesthetic?  We install LED under cabinet lighting in a home virtual everyday.  This task is a highly requested item.  We also add recessed lighting.  Recessed lighting can add general illumination or accent a wall or nich.

Have a rental property in Des Moines?  Our company handles a lot of calls for landlords needing electrical items brought up to code or repaired.  Our certified electricians are on call offering 24 hour servicing for those unexpected emergencies. We can perform a code update, panel replacement, ground an outlet, or rewire your property.  No job is to big or to small.