This Valentine’s day, show your partner how deep your love runs for him or her by cleaning all the neglected kitchen appliances! Chocolates, flowers, and jewelry are nice too, don’t get us wrong. It’s just that serious cleaning says a lot about how much a person cares. By tackling these uncharted territories, not only will the love your partner has for you grow, you may even rekindle the love you once had for your home. That’s a whole lot of love going around.

Can you remember the last time you cleaned the inside of your refrigerator or behind it? It isn’t the easy appliance to maneuver around, so it’s likely that you haven’t cleaned behind it since you moved in. To clean your refrigerator, first pull it out so that you can mop up the dirt, debris, and gunk that’s been left behind. Then, vacuum the coils, which are located either behind or beneath your refrigerator.

All refrigerators are equipped with door gaskets to prevent cold air from escaping. If you have loose gaskets, read through your owner’s manual to find out the replacement part numbers. Your local hardware store should have gaskets in stock.

Make the outside of your fridge sparkle with a solution of equal parts water and white vinegar. If you have a stainless steel fridge, rub in the direction using either a paper towel or a soft wash cloth.

Now that the outside of your fridge looks brand new, it’s time to tackle the other not-so fun part, which is the inside. Clean all shelves and crispers. Perhaps you can use this time to throw away all your expired foods and beverages that you forgot existed.

Even if you have the luxury of owning a self-cleaning oven, some work is still required on your part. Using a solution of equal parts water and vinegar, wipe down the door hinges and frames. You can tackle the particularly rough spots with a some baking soda and a sponge.

How to Clean Your Stovetop:

Soak your burners with hot, soapy water for a few hours, and then scrub. The drop plate may be the dirtiest component of your stove. Before your scrub this area, use a vacuum to get out all the accumulated gunk.

To loosen up all the baked-on foods in your microwave, fill a microwave-safe container with water and heat it until it boils. Wait a few minutes before opening the door so that the steam can do its job; then wipe.

We know how counter-intuitive this sounds, but trust us – it’s a task that needs to be done! Your dishwasher works day in and day out to clean your dishes; it’s only a matter of time before all the gunk accumulates.

If your planning to cook dinner for your partner this Valentine’s Day, he or she will notice how sparkling-clean the plates are!

In all the hustle and bustle of the day, it’s easy to get sidetracked or to not pay close enough attention in the kitchen. In a matter of just a few seconds, your kitchen can go from being the heart of your home to being a disaster zone. Every year, there’s a significant spike in home fires on Thanksgiving and Christmas. Ensure the safety of your family by following these tips!

We know that today may be incredibly busy for you, so we wanted to do our part to help make it easier. We’ve created a printable graphic that you can pin to your refrigerator to remind you of the important tips you need to follow.

LED lights are also measured in two different ways; by their color temperature and the lumens they produce. Because they use significantly less power and are gaining in efficiency with each generation, whereas older bulbs are consistent in their wattage being representative of the amount of light put out, LED bulbs can vary in efficiency a bit more. What this means is that the bulbs are now rated by their Lumen rating, or how much light they put out, versus how much power they draw. Understanding how LEDs work and the opportunities that they present to you as a homeowner are key to helping you make a decision as to how you light your home.

On any job site, having the right electrical safety gear is essential. For electrical projects, there are often special considerations, as some tasks can have unique hazards that require special gear.

Eye injuries are serious and for most electricians are a daily hazard. Having, and using, the right eye protection can make all the difference.

Electricians often work at heights, either on roofs, scaffolds, or elevated work platforms. In some locations, even working on a step ladder can require fall protection gear.

When the potential exists to fall more than 6 ft., fall protection gear should be worn. This includes an approved and inspected harness and a lanyard with the correct weight rating. Always ensure that the fully extended length of the lanyard is short enough to prevent the worker from contacting the ground in the event of a fall.

Hand injuries are the most common type of workplace injury, therefore selecting and using the right kind of gloves is vital.

Along with proper knife safety practices, using cut-resistant Kevlar gloves can greatly reduce the potential for cuts and scratches. In cold weather, ensure that insulated gloves are worn. When dealing with potentially hazardous chemicals, use gloves rated to handle the specific associated hazards.