The weather is starting to get cooler, and as summer rolls into fall, we thought we’d remind everyone of ways they can keep their homes safe from fires!

Check your smoke detectors—you should test your smoke detectors twice a year—once in the spring, once in the fall. In addition, remember that smoke detectors are designed to last 10 years. If yours is older than that, it’s highly recommended that you install a new one. New smoke detector laws that went into effect earlier this year require all new smoke detectors to have 10-year batteries, so you don’t have to worry about replacing the batteries along the way.

Check carbon monoxide (CO) detectors—having a smoke detector isn’t enough anymore; if you want to keep your family totally safe, you need to also install a carbon monoxide detector. Carbon monoxide is an odorless, colorless, and highly toxic gas that can be deadly even in small amounts and can be released by any faulty gas appliance, including furnaces and fireplaces. Your best bet? Install a combination smoke alarm/carbon monoxide alarm for maximum protection.

Inspect your extension cords—with the holidays coming up, you’re going to want to make sure your extension cords are in good shape and not damaged or frayed. Any extension cords you’re planning on using outdoors should be weather-rated. Inside, make sure you use surge protectors and power strips with internal overload protection, and make sure you minimize the amount of adapters plugged into a single outlet.

Be careful with space heaters—space heaters are convenient, but can be a major fire hazard if you’re not careful with them. Make sure there is nothing flammable within three feet of the space heater, and never plug it into an extension cord.

Protect your outdoor electrical systems—any outdoor electrical outlets should be GFCI outlets and covered by a “bubble cover” to keep the elements out. If your electrical service cable is exposed, make sure it’s not damaged. During the holidays, don’t hang any decorations on or near the cable.

Install arc fault circuit interrupters—these are not required by building codes, but they offer a higher level of protection for your electrical system and are generally highly recommended. Arc fault circuit interrupters (AFCI) are designed to detect an unintended electrical arc and disconnect the power before an electrical fire can start.  They are the safest way to protect a home from the risk of electrical fire.

If you’re at all concerned with your home’s electrical safety this year, don’t take chances—call Kolb Electric! We can upgrade your home’s electrical service in any way you need, from installing smoke detectors and adding outlets to a full-on heavy up. Don’t gamble on fire safety—call Kolb Electric today!

When you plug something into an outlet in your home, you probably don’t really take the time to think about where the electricity to power your appliance comes from. You plug it in, it works. But, what do you do when it doesn’t work?

Homeowners are constantly making improvements to their home. This may include upgrading or installing a new air conditioning unit, replacing the old fridge with a newer, more family-friendly model or adding a hot tub to the backyard. If you have already made these investments or are considering making them, you should contact your electrician. Beverly Hills residents can rely on the professionals at The Electric Connection to provide fast, friendly and knowledgeable service.

An electrical inspection will be needed to determine whether or not your existing electrical panel can handle these much larger items. Hot tubs, AC units and larger power tools will need more power than the typical appliance. If you have a newer home, it is a fairly simple process for an electrician to install the outlet needed to power the new item.

Older homes may need an electrical panel upgrade to support the electricity demands. An additional breaker may need to be added. In fact, this is may apply to newer homes as well, depending on the service that was put in during construction of the home.

If you have already hooked up a new refrigerator or stove and notice you seem to be tripping breakers, it is likely you need an upgrade. This is a sign there is too much draw on a breaker or that a breaker is weak. An electrician in Beverly Hills will be able to determine what the problem is during the inspection. If you are ready to take care of those tripping breakers or have more questions about what it takes to get your new appliance properly wired, give The Electric Connection a call.

A Look Back At 2011

Texas residents suffered damaging and costly electrical problems in 2011. Three major blackout incidents, two of which happened in the winter months of February and December respectively, left residents without heat and without power for hours and, in some cases, days at a time. Equally distressing was the 71-day drought that had Texans begging their local Dallas electrician for relief, as 100-plus degree heat waves weakened the power grid once again and left residents without air conditioning or electricity.

2012: Not Much Better

Unfortunately, 2012 does not seem to be the year for relief. Experts warn that several factors point to an even more severe blackout and power grid problem in the state of Texas for 2012.

 These factors translate into miserable, costly blackouts and power grid failures throughout North Texas.

Dallas Electrician Company Provides Solutions

There are some solutions for customers looking stay ahead of the game when it comes to protecting their home and appliances from the inconvenient and sometimes dangerous conditions that stem from power grid failures. With the help of a knowledgeable electrician, Dallas residents can acquire an indoor generator, which can serve as an effective emergency power source for your home or business in the event of a blackout.

One of the most convenient features of these indoor generators is that there is no need to use electricity to recharge the battery bank that runs the generator. Without the mess of a fuel-powered engine generator, customers can count on reliable and steady power output and a quiet supply of power for your appliances. Furthermore, the convenience of a solar-power or wind-power battery charge ensures that customers need not worry about using electricity to recharge generator batteries.

For anyone who is in control, manages, or even owns a facility that has a parking lot for either employees, customers and clients, or both; you know that security and protection of everyone is paramount.

With outdated, inefficient, and low quality output per watt, which is all that matters when it comes to getting the most efficient lighting. The reasons behind this is because let’s say you have two different LEDs products, one outputs 135 lumens per watt while the other is at 120 lumens / watt. To power a light that outputs at 18,000 lumens; the 120 lumen per watt fixture will take 150 watts to reach 18,000 total lumens. While the 135 lumen per watt fixture will only require approximately 133 watts to generate same exact amount of light that the other higher watt fixture products.

See the important of lumens per watt? It’s everything, and we believe

Here’s another project of ours where we retrofitted an existing fixture in a parking lot (before and after):

The image list could go on, but the gist is this: LED has and will always improve your facility’s lot. Just look at the images yourself for the proof!

By choosing LED parking lot products for your facility, you are choosing higher quality along with higher efficiency products. LEDs (more specifically MyLEDLightingGuide’s) offer a better Color Rendering Index rating talked about before is about lumen depreciation. Metal halide and HPS experience greater and quicker depreciation in lumen output than any LED product does. So while a brand new and freshly installed metal halide fixture may look the same as an LED to start off its life; give it a few years and watch the difference. LED is almost guaranteed to be brighter for longer.

On the topic of saving money, how about the final benefit that will make you fall in love with LED technology and what it can do for your business.

While you need to be careful which LED products you purchase and from where you buy them from; commercial LEDs are just as open to rebates as any other.

Something called DesignLights Consortium (DLC for short) qualifies products and lists them on their site if they pass vigorous tests set by them. They offer two types of listing: commercial rebates but they also prove to be lesser of quality. Think; if a company offers quality lights what’s their reason not to get qualified? There isn’t, and that’s exactly our point.

Thankfully there are many DLC qualified products out their on the market, including ours. You can always take a look around just to say hi!