By providing early warning in the event of fire, smoke detectors can allow you and your family sufficient time to reach safety. Experts report that you can increase your chances of surviving in a home fire by 50% simply by having smoke detectors. Click here for more information about installing  smoke detectors in Los Angeles, my electrical company’s service area.

If your house was built before 1950, it likely has electrical wires with cloth insulation. Over time, the cloth dries out and becomes brittle. Eventually, it crumbles off the wire, exposing bare wires that can short-circuit and cause shocks or fires. Old cloth-insulated wires should be replaced with plastic-insulated wires. Plastic insulation lasts indefinitely and completely resolves the safety issue. Click here for more information about replacing cloth  wiring insulation.

The National Electrical Code requires that outlets in the vicinity of water be equipped with a device called a “Ground Fault Circuit Interrupter” or GFCI (also called GFI). GFCIs are required in all bathrooms, kitchens, garages, pools, and some outdoor areas. GFCIs can protect your family against deadly electrical shocks and are inexpensive to install. Click here for more information about GFCIs and GFIs.

Knob & Tube wiring gets its name from the white ceramic knobs around which wires were wound and the short ceramic tubes through which wires were guided. This type of wiring is usually found in homes built before 1935. In the Los Angeles and some other parts of the country, knob and tube can sometimes be seen in houses built as late as 1950. My electrical company specializes in replacing Knob and Tube wiring in the L.A. area — much of it is in Pasadena and other parts of the San Gabriel Valley.

Knob & Tube systems use old cloth-insulated wires and are not grounded. We strongly recommend that Knob & Tube wiring be replaced to eliminate fire and electrical shock hazards.

An electrical surge is a sudden increase in power that flows through electrical wires. Surges can cause damage to computers, phones, entertainment systems, microwaves, stoves, fridges, washers – any device that has electronic components such as sensors and timers. Today, that’s most appliances. A Whole House Surge Protector can save your appliances and electronic devices and save you thousands of dollars in damage.

Look for our $50 discount coupon for the installation of whole house surge protectors at www.theelectricconnection.com.

A properly grounded electrical system routes occasional leaking electricity through a “ground wire” into the ground. Without grounding, excess electricity can cause fires, damage to electrical appliances and computers, and also shocks to residents.

Older homes built under earlier electrical codes will often have outlets for two-prong plugs. This is often an indication of an ungrounded electrical system. Sometimes, the outlets have been replaced with the modern three-prong type, but without actually adding a ground wire. This can make it appear that the system is grounded when it’s not.

Even when your wiring system has a ground wire, the grounding may fail due to loose or corroded connections and splices. A qualified electrician can check your wiring with a special tester to determine if it’s fully grounded. The Electric Connection offers this testing as a free service with every electrical job that we do in the L.A. area.

There is now conclusive evidence that both Zinsco and Federal Pacific Electric (FPE) “Stab-Lok” electrical panels can fail. (Electrical panels contain your circuit breakers or fuses.) Fires and electrical shocks can result. These brands were installed in the 1950s to 1980s. The failure rates as they age are much higher than for other brands and represent a real electrical hazard. We recommend all Zinsco and FPE electrical panels and circuit breakers be replaced with modern electrical equipment. Click here for more information about Zinsco and Federal Pacific electrical panels. One of the specialties of The Electric Connection is panel upgrades. We’re possibly the most active company in Los Angeles when it comes to electrical panel replacements. We offer a free safety check of your L.A. electrical panel box with every job.

Circuit breakers and fuses protect your electrical wiring from overloads of electricity. Overloading can melt wires and cause fires and electrical shocks. Whenever a wire is overloaded, the circuit breaker or fuse is supposed to cut the flow of electricity.

Sometimes older circuit breakers don’t work fast enough and allow too much current through. Fuses can also be a safety concern. Sometimes, they’ve been replaced with improperly-sized fuses and no longer protect wires from overloading. These safety issues can be solved by installing modern circuit breakers. Click here for a coupon for a free check of your electrical circuit breaker box with your next electrical job.

Most homes have copper electrical wires. However, from the mid-1960s to the mid-1970s, over 2,000,000 U.S. homes were wired with aluminum. The U.S. Consumer Products Safety Commission has determined that aluminum wiring is hazardous as, over time, connections and splices can fail, resulting in fires and shocks.

Fortunately, a qualified electrician can upgrade an aluminum wiring system without replacing all the wires with copper. It’s possible to eliminate the fire hazard by upgrading only connection points and splices. Aluminum wiring safety retrofits should be done only by electricians specifically trained to upgrade aluminum wiring safely.

If you think it’s possible that your Los Angeles home has aluminum wiring, you can get a free checkwith your next electrical job. One of the specialties of The Electric Connection is efficient and effective safety upgrading of aluminum wiring in the Los Angeles area.

Click here to visit our website.

This Valentine’s day, show your partner how deep your love runs for him or her by cleaning all the neglected kitchen appliances! Chocolates, flowers, and jewelry are nice too, don’t get us wrong. It’s just that serious cleaning says a lot about how much a person cares. By tackling these uncharted territories, not only will the love your partner has for you grow, you may even rekindle the love you once had for your home. That’s a whole lot of love going around.

Can you remember the last time you cleaned the inside of your refrigerator or behind it? It isn’t the easy appliance to maneuver around, so it’s likely that you haven’t cleaned behind it since you moved in. To clean your refrigerator, first pull it out so that you can mop up the dirt, debris, and gunk that’s been left behind. Then, vacuum the coils, which are located either behind or beneath your refrigerator.

All refrigerators are equipped with door gaskets to prevent cold air from escaping. If you have loose gaskets, read through your owner’s manual to find out the replacement part numbers. Your local hardware store should have gaskets in stock.

Make the outside of your fridge sparkle with a solution of equal parts water and white vinegar. If you have a stainless steel fridge, rub in the direction using either a paper towel or a soft wash cloth.

Now that the outside of your fridge looks brand new, it’s time to tackle the other not-so fun part, which is the inside. Clean all shelves and crispers. Perhaps you can use this time to throw away all your expired foods and beverages that you forgot existed.

Even if you have the luxury of owning a self-cleaning oven, some work is still required on your part. Using a solution of equal parts water and vinegar, wipe down the door hinges and frames. You can tackle the particularly rough spots with a some baking soda and a sponge.

How to Clean Your Stovetop:

Soak your burners with hot, soapy water for a few hours, and then scrub. The drop plate may be the dirtiest component of your stove. Before your scrub this area, use a vacuum to get out all the accumulated gunk.

To loosen up all the baked-on foods in your microwave, fill a microwave-safe container with water and heat it until it boils. Wait a few minutes before opening the door so that the steam can do its job; then wipe.

We know how counter-intuitive this sounds, but trust us – it’s a task that needs to be done! Your dishwasher works day in and day out to clean your dishes; it’s only a matter of time before all the gunk accumulates.

If your planning to cook dinner for your partner this Valentine’s Day, he or she will notice how sparkling-clean the plates are!

Power outages can be a nuisance during any season. Power lines can be brought down by car accidents, windstorms, snowstorms, and many other uncontrollable factors; this inconvenience can easily be avoided by having a standby generator. Whether you are a business that needs operations to continue or at home looking to stay warm, a standby generator is a great idea.

A standby generator houses an engine that is powered by gas, propane, or diesel. When you lose electrical flow you can turn on the generator to create a new supply of electricity. Depending on how the generator is installed, this transition can be seamless so the generator will take over when you lose power. Unlike a portable generator, a standby generator is positioned on a concrete pad outside of your home.

Standby generators are a great idea for businesses. Downtime caused by a power outage can hurt any type of business, especially if your business depends on electricity for its main components. Having an office full of workers with computers that don’t turn on is not a productive environment. Similarly, businesses that have critical components that run off electricity, such as gas stations, will be rendered useless without a backup power supply.

Standby generators are also a smart choice for residential use. Losing air conditioning or heating can create an uncomfortable environment. Those with medical equipment at home will also need a continuous supply of power or there could be life-threatening consequences.

While electricity may be one of the greatest inventions, it still has its weaknesses. To keep your home and business covered from unexpected power outages have a standby generator installed. Our Expert Electricians can help to advise you and install your generator so you can have peace of mind during events out of your control. If you have any questions or want to get started contact your local Expert Electrician.

Roof replacement is rarely a happy job. It's messy, time-consuming and expensive. If it's time for you to install a new roof, however, you can make the best of it by including energy-saving features that can cut down on your utility bills and take some of the sting out of the expense. Check out these ideas for energy-efficient roofs that will save you money and make your house the envy of the neighborhood.

Whatever efficiency measures you choose for your new roof, you can feel good about reducing your energy consumption, meaning you're lessening your reliance on fossil fuels and the accompanying contributions to climate change. And you’ll definitely feel smart when the utility bills arrive. For more ideas about how to get the most from your roof, contact a home services professional today.

Electricity gives us light, warmth and many of the conveniences of modern life. It powers industry, our homes, our schools and our offices, yet most of us take it for granted. Do you know where your electricity comes from or how it reaches you to provide the energy you depend on? It's Grid Week, and the Department of Energy's Understanding the Grid infographic gives a bite-size education on how electricity is generated, transmitted and distributed to our homes and businesses.