Take a few minutes to look for and correct electrical hazards in your home. It does not take too long to check the insulation on a table lamp cord, check for the correct wattage light bulbs and install a GFCI (Ground Fault Circuit Interrupter). Take the time. It will prevent an electrical safety hazard and save you and your loved ones lives.

Unsafe conditions such as overloaded circuits and damaged insulation as well as the misuse of extension cords and electrical devices create fire hazards and may result in serious electrical injury.

Studies of residential electrical fires show that the majority of serious fires could have easily been avoided. The conditions that caused the fires probably would have been detected by an electrical inspection. These problems were not detected or corrected because no inspections had been made for several years. In a number of cases homes ranging from 30 to 100 years old had not been inspected since they were built. A safety inspection should be performed by a qualified licensed electrician.

One good tip to determine when your electrical system was last inspected is to examine the door and cover of your electrical panel. The panel should contain a label or tag with a date, a signature, or initials on it. If there is more than one date, the most recent one should be the date of the last inspection. DO NOT remove the service-panel cover. This is a job for a qualified electrician. If the date is older than ten years, its time for a inspection and correction of any problems that show.

Call us for help at 808-647-0599

Finding the right electrician for your Tampa business is about more than just needing to get a single project done. Electrical needs in modern commercial settings are constantly evolving, meaning you need a trustworthy professional at your side and ready to serve when you need them most. Trouble is, there are tons of electrician to choose from! So how do you single out the best electrician for your needs? The team at Hoffman Electrical weighs in with our handy checklist!

Do you have lots of electrical devices at home? Are they protected against damage? We are not talking about physical damage that is caused by dropping or breaking them accidentally but rather of electrical damage. When there are instances of electrical overload, power surges or even extreme weather conditions such as lightening, etc., your electrical devices will be at a risk of getting fried due to the excessive electricity passing through them.

This is why you should ground the electrical devices. Grounding provides a path for the excessive electricity to flow to the earth instead of you or any electrical device, thus preventing electricity shock or damage. Let us how it works.

How Does Grounding Work?

In any electric circuit, there is an active wire which supplies the power, a neutral wire which carries that current back and a ‘grounding wire’ which provides an additional path for electrical current to return safely to the ground without causing danger to anyone in the event of a short circuit. A copper conductor is connected from the metal rod of the wiring system to a set of terminals for ground connections in the service panel.